Mitsubishi Q00JCPU User Manual page 429

8
PARAMETERS
(2) PLC system
Item Parameter No.
Low speed
Timer limit
1000
setting
High speed
RUN
RUN-
PAUSE 1001
contact
PAUSE
Remote reset 1002
Output mode at STOP to
1003
RUN
Floating point arithmetic
1004
*1
processing
Intelligent function
module setting (interrupt 100A
pointer setting)
Common pointer No. 1005
Make setting necessary to use the CPU module.
The parameters may be the default values to perform control.
Table8.13 PLC system list
Description
Set the time limit of the low
H
speed timer/high speed timer.
Set the contact that controls
RUN/PAUSE of the CPU
module. Setting of only the
PAUSE contact is not allowed.
H
(The RUN contact or RUN
contact and PAUSE contact can
be set.)
Set enable/disable of remote
reset operation from GX
H
Developer.
Set the output (Y) status when
the STOP status is switched to
H
the RUN status.
Set whether the floating-point
operation processing is
H
performed with double precision
or not.
Set the assignment of the
interrupt pointers (I50 to 255)
and the start I/O No. and start SI
H
No. of the intelligent function
module.
Set the start No. of the pointers
H
used as common pointers.
* 1 : Cannot be set when the Process CPU or Redundant CPU is used.
8.1.2 High Performance model QCPU, Process CPU, Redundant CPU
Diagram 8.13 PLC system
Setting range
1ms to 1000ms (1ms unit) 100ms
0.1ms to 100.0ms (0.1ms unit) 10.0ms
X0 to 1FFF No setting
Enable/disable Disable
Provide output (Y) status before
Provide output (Y)
STOP/Clear output (Y) (output
status before STOP
one scan later)
Perform floating-
Perform/Do not perform floating-
point operation
point operation processing with
processing with
double precision
double precision
Start I/O No.
Start SI No. No setting
I50 to 255
P0 to 4095 No setting
8.1 PLC Parameters
Default value Reference
Section 9.2.10
Section 9.2.10
Section 6.6.1
Section 6.6.2
Section 6.6.3
Section 6.4
Section 3.9.4
Section 9.10
Section 9.9.2
(Continued on next page)
8
- 15
1
2
3
4
5
6
7
8