Mitsubishi Q00JCPU User Manual page 442

8
PARAMETERS
Redundant
(12) Multiple CPU setting
Note8.1
Item Parameter No.
Number of PLC 0E00
Operation mode 0E01
Online module change
E006
(hot swapping) setting
Note1
Redundant
Note8.1
8
8.1 PLC Parameters
- 28
8.1.2 High Performance model QCPU, Process CPU, Redundant CPU
Make setting to configure a multiple CPU system.
Table8.23 Multiple CPU setting list
Description
Set the number of CPU modules
used by the multiple CPU
H
system.
Set the multiple CPU system
operation to be performed when
any of the CPU modules No. 2 to
No. 4 results in a stop error.
H
When the CPU No. 1 results in a
stop error, the multiple CPU
system stops. (Fixed)
Set whether online module
change (hot swapping) is
enabled or disabled in the
multiple CPU system. (When
H
enable is selected, the non-
group I/O status cannot be
imported.)
Since the Redundant CPU cannot use a multiple CPU system, it cannot use the multiple CPU
setting.
Note8.1
Note1
Diagram 8.23 Multiple CPU setting
Setting range
1 to 4 modules
Stop/Do not stop all CPUs at
error of CPU No. n
Enable/Disable online module
change (hot swapping) of other
CPU modules.
Default value Reference
1 module
QCPU User's Manual
(Multiple CPU
System)
Stop all CPUs at
error of CPU No. n
• High
Performance
QCPU User's Manual
model QCPU:
(Multiple CPU
Disable
System)
• Process CPU:
Enable
(Continued on next page)