11
PROCEDURE FOR WRITING PROGRAM TO CPU
MODULE
11.1.3 Procedure for writing program
This section explains the procedure for writing the parameters and program created by GX
Developer to the Basic model QCPU.
This section explains the procedure for writing a program to the program memory (
Section 5.1.2).
When storing the program into the standard ROM and executing boot run, perform the
procedure given in this section, and then carry out the procedure given in Section 11.1.4.
Procedural steps shown in
shown in
boxes are performed at the GX Developer, and those
boxes are performed in the Basic model QCPU.
Start
Start GX Developer.
Set the project.
Do you
NO
change the number
of device points
used?
YES
Change the number of device points in
device setting of PLC parameter.
Create a program to be executed in the
CPU module.
1)
GX Developer Operating Manual
Section 9.2
Ladder (write) screen
............
11.1 Basic Model QCPU
11.1.3 Procedure for writing program
9
10
11
11
- 4