Mitsubishi Q00JCPU User Manual page 468

9
DEVICE EXPLANATION
(6) Annunciator OFF procedure and processing content
Basic
Note9.4
Remark
Note4
Basic
Note9.4
9
9.2 Internal User Devices
- 17
9.2.5 Annunciator (F)
(a) Annunciator OFF procedure
The annunciator can be turned OFF by any of the following instructions.
1) RST F instruction
An annunciator No. which has been switched ON by the SET F
can be switched OFF by the RST F instruction.
2) LEDR instruction
The LEDR instruction is used to switch OFF the annunciator Nos. stored at
SD62 and SD64.Note4
3) BKRST instruction
The BKRST instruction is used to switch all the annunciator Nos. within a
specified range.
4) OUT F instruction
The OUT F instruction can execute ON/OFF of the annunciator No. by the
same instruction.
However, if an annunciator is switched OFF by the OUT F instruction, the
"processing at annunciator OFF" ( (6)(b) in this section) is not performed.
Execute the RST F , LEDR or BKRST instructions after the annunciator has
been switched OFF by the OUT F instruction.
• When turning OFF annunciator 5 (F5)
Fault detection program
(Annunciator ON program)
Display reset input
• To switch OFF all annunciators which are ON:
Fault detection program
(Annunciator ON program)
Display reset input
Refer to the following manual for details of each instruction.
QCPU (Q Mode)/QnACPU Programming Manual (Common Instructions)
The Basic model QCPU cannot use the LEDR instruction.
Note9.4
RST F5
BKRSTP F0 K10
Diagram 9.13 Example of turning OFF the annunciators
Program that turns OFF
annunciator 5 (F5)
F0 to F9 OFF program
instruction