Mitsubishi Q00JCPU User Manual page 590

11
PROCEDURE FOR WRITING PROGRAM TO CPU
MODULE
11
11.2 High Performance Model QCPU, Process CPU, Redundant CPU
- 11
11.2.3 Procedure for writing one program
1)
NO
Use the device
initial value?
YES
Set the device memory.
Set the device initial value range.
In the PLC file setting of the PLC
parameter dialog box, set the device
initial value file name.
Set the parameter-valid drive of the DIP
switches (SW2, SW3)."
Connect the personal computer, which is
installed with GX Developer, to the CPU
module.
Set the RUN/STOP switch to STOP and
the RESET/L.CLR switch to the neutral
position, and power ON the PLC (the
ERR. LED turns on).
2)
* 1 : By default, the parameter-valid drive is set to the program memory (Drive 0) with the DIP switches.
(SW2: OFF, SW3: ON)
When writing the parameters to the standard ROM or memory card, change the parameter-valid
drive with the DIP switches.
* 2 : Refer to the following manual for the procedure when the Redundant CPU is used.
QnPRHCPU User's Manual (Redundant System)
Section 6.26
Section 6.26
Section 6.26
1
Part names and settings of QCPU
User's Manual
(Hardware Design, Maintenance
and Inspection)
2