Engine Assembly Installation; Inspect Intake Manifold; Install Engine Oil Pressure Switch Assembly - Toyota 2GR-FE Manual

2GR-FE ENGINE MECHANICAL – ENGINE ASSEMBLY
Cylinder head side:
Surge tank side:
Adhesive
4.

INSPECT INTAKE MANIFOLD

(a) Cylinder head side:
(1) Using a precision straightedge and feeler
gauge, measure the surface contacting the
cylinder head for warpage.
Maximum warpage:
(b) Surge tank side:
(1) Using a precision straightedge and feeler
gauge, measure the surface contacting the
surge tank for warpage.
Maximum warpage:
A134934E01
INSTALLATION
1. INSTALL ENGINE COOLANT TEMPERATURE
SENSOR
(a) Using a 19 mm deep socket wrench, install the
engine coolant temperature sensor and a new
gasket.
Torque: 20 N*m (200 kgf*cm, 14 ft.*lbf)
2. INSTALL KNOCK CONTROL SENSOR (See page
511)
A129648
3. INSTALL ENGINE OIL PRESSURE SWITCH
ASSEMBLY
(a) Clean the threads of the oil pressure switch. Apply
adhesive to 2 or 3 threads of the oil pressure switch.
Adhesive:
Part No. 08833-00080 THREE BOND 1344,
LOCTITE 242 or equivalent
P012478E01
(b) Using a 24 mm deep socket wrench, install the oil
pressure switch.
Torque: 21 N*m (214 kgf*cm, 15 ft.*lbf)
NOTICE:
Do not start the engine within 1 hour after
installation to prevent oil leaks.
A129647
0.1 mm (0.003 in.)
If the warpage is greater than the
maximum, replace the intake manifold.
0.1 mm (0.003 in.)
If the warpage is greater than the
maximum, replace the intake manifold.
EM–37
EM
ES-