Toyota 2GR-FE Manual page 655

ES–490
ES
2GR-FE ENGINE CONTROL SYSTEM – VVT SENSOR
REMOVAL
1. REMOVE ENGINE UNDER COVER LH
2. REMOVE ENGINE UNDER COVER RH
3. DRAIN ENGINE COOLANT (See page CO-5)
4. REMOVE WINDSHIELD WIPER ARM AND BLADE
ASSEMBLY LH (See page WW-9)
5. REMOVE WINDSHIELD WIPER ARM AND BLADE
ASSEMBLY RH (See page WW-9)
6. REMOVE FRONT FENDER TO COWL SIDE SEAL LH
(See page WW-9)
7. REMOVE FRONT FENDER TO COWL SIDE SEAL RH
(See page WW-9)
8. REMOVE COWL TOP VENTILATOR LOUVER SUB-
ASSEMBLY (See page WW-10)
9. REMOVE WINDSHIELD WIPER MOTOR AND LINK
(See page WW-10)
10. REMOVE COWL TOP PANEL OUTER SUB-
ASSEMBLY (See page ES-481)
11. REMOVE COOL AIR INTAKE DUCT SEAL (See page
EM-23)
12. REMOVE V-BANK COVER SUB-ASSEMBLY (See
page EM-23)
13. REMOVE AIR CLEANER INLET ASSEMBLY (See
page EM-24)
14. REMOVE AIR CLEANER CAP SUB-ASSEMBLY (See
page ES-503)
15. REMOVE AIR CLEANER CASE SUB-ASSEMBLY (See
page EM-24)
16. REMOVE NO. 1 AIR CLEANER INLET (See page
24)
17. REMOVE INTAKE AIR SURGE TANK ASSEMBLY
(See page FU-13)
18. REMOVE VVT SENSOR (for Bank 1 Intake Side)
(a) Disconnect the VVT sensor connector.
(b) Remove the bolt and VVT sensor.
A135701
EM-