Toyota 2GR-FE Manual page 771

CO–6
CO
2GR-FE COOLING – COOLANT
8. ADD ENGINE COOLANT
(a) Close the radiator drain cock plug and 2 cylinder
block drain cock plugs.
Torque: 13 N*m (130 kgf*cm, 9 ft.*lbf) for
(b) Slowly fill the radiator with TOYOTA Super Long Life
Coolant (SLLC).
Specified capacity:
9.0 liters (9.5 US qts, 7.9 lmp. qts)
HINT:
• TOYOTA vehicles are filled with TOYOTA SLLC
at the factory. In order to avoid damage to the
engine cooling system and other technical
problems, only use TOYOTA SLLC or similar
high quality ethylene glycol based non-silicate,
non-amine, non-nitrite, non-borate coolant with
long-life hybrid organic acid technology (coolant
with long-life hybrid organic acid technology
consists of a combination of low phosphates and
organic acids).
• Contact your TOYOTA dealer for further details.
(c) Slowly pour coolant into the radiator reservoir tank
until it reaches the FULL line.
(d) Press the inlet and outlet radiator hoses several
times by hand, and then check the level of the
coolant.
If the coolant level is low, add coolant.
(e) Install the radiator cap sub-assembly and reservoir
tank cap.
(f) Start the engine, and warm it up.
HINT:
Adjust the air conditioner set temperature to MAX
(HOT).
(g) Stop the engine, and wait until the engine coolant
cools down.
(h) Add engine coolant to the FULL line on the radiator
reservoir.
9. CHECK FOR ENGINE COOLANT LEAKS (See page
CO-1)
10. INSTALL V-BANK COVER SUB-ASSEMBLY (See
page EM-52)
11. INSTALL ENGINE UNDER COVER RH
12. INSTALL ENGINE UNDER COVER LH
13. INSTALL FRONT WHEEL OPENING EXTENSION PAD
RH
14. INSTALL FRONT WHEEL OPENING EXTENSION PAD
LH
15. INSTALL COOL AIR INTAKE DUCT SEAL (See page
EM-52)
cylinder block drain cock plug