Toyota 2GR-FE Manual page 119

EM–118
Projection
Number Mark
EM
Less than 6 mm (0.23 in.)
Bolt Length 100 to 102 mm
(3.94 to 4.02 in.)
2GR-FE ENGINE MECHANICAL – ENGINE UNIT
(b) Confirm the projection and numbers of the main
(c) Apply a light coat of engine oil to the threads and
(d) Temporarily install the 8 main bearing cap bolts to
A121711E02
(e) Insert the main bearing cap with your hand until the
A134893E01
(f)
(g) Apply a light coat of engine oil to the threads and
A131829
bearing caps and install the bearing caps on the
cylinder block.
HINT:
A number is marked on each main bearing cap to
indicate the installation position.
under the heads of the bearing cap bolts.
the inside positions.
clearance between the main bearing cap and the
cylinder block is less than 6 mm (0.23 in.) by
marking the 2 internal bearing cap bolts as a guide.
Bolt length:
100 to 102 mm (3.94 to 4.02 in.)
Using a plastic hammer, lightly tap the bearing cap
to ensure a proper fit.
under the heads of the 8 main bearing cap bolts.