Toyota 2GR-FE Manual page 120

Bolt Length 105.5 to 107.5 mm
(4.15 to 4.23 in.)
15
11
7
3
8
4
16 12
90°
Engine Front
4
1
2
3
8
2GR-FE ENGINE MECHANICAL – ENGINE UNIT
(h) Install the 8 main bearing cap bolts to the outside
(i)
A134894E01
(j)
9 13
1
5
2
6
10
14
A134892E02
(k) Step 2
Paint Mark
A051462E03
(l)
(A)
7
Item
6
Bolt A
5
Except bolt A
(m) Check that the crankshaft turns smoothly.
A129721E05
positions.
Install the crankshaft bearing cap bolts.
HINT:
The main bearing cap bolts are tightened in 2
progressive steps.
Step 1
(1) Install and uniformly tighten the 16 main
bearing cap bolts in the sequence shown in the
illustration.
Torque: 61 N*m (622 kgf*cm, 45 ft.*lbf)
If any of the main bearing cap bolts does not
meet the torque specified, replace it.
(1) Mark the front of the bearing cap bolts with
paint.
(2) Retighten the bearing cap bolts by 90° in the
order above.
(3) Check that the painted mark is now at a 90°
angle to the front.
Install 8 new seal washers and uniformly tighten the
8 main bearing cap bolts in several steps and in the
sequence shown in the illustration.
Torque: 52 N*m (525 kgf*cm, 38 ft.*lbf)
Bolt length
EM–119
Length
45 mm (1.77 in.)
30 mm (1.18 in.)
EM