Toyota 2GR-FE Manual page 478

ES–322
(f) According to the display on the tester, read the "DATA LIST".
Item
PNP SW [NSW]
REVERSE
DRIVE
ES
1
CHECK HARNESS AND CONNECTOR (BATTERY - PARK / NEUTRAL POSITION SWITCH)
Wire Harness Side:
Park / Neutral Position SW
C1
5
OK
2
CHECK ECM (OUTPUT SIGNAL)
Wire Harness Side:
Park / Neutral Position SW
C1
5
2GR-FE ENGINE CONTROL SYSTEM – SFI SYSTEM
Measurement Item / Range
(Display)
PNP SW Status / ON or OFF
PNP SW Status / ON or OFF
PNP SW Status / ON or OFF
1 2
3 4
6 7 8 9
C117645E10
1 2
3 4
6 7 8 9
C117645E10
Normal Condition
Shift lever position is;
P and N: ON
Except P or N: OFF
Shift lever position is;
R: ON
Except R: OFF
Shift lever position is;
D and S: ON
Except D or S: OFF
(a) Disconnect the park / neutral position switch connector.
(b) Turn the ignition switch on (IG).
(c) Measure the voltage according to the value(s) in the
table below.
Standard voltage
Tester Connection
2 - Body ground
NG
REPAIR OR REPLACE HARNESS OR
CONNECTOR
(a) Turn the ignition switch on (IG).
(b) Measure the voltage according to the value(s) in the
table below.
Standard voltage
Tester Connection
4 - Body ground
NG
Go to step 9
Diagnostic Note
When the shift lever position
displayed on the intelligent tester
differs from the actual position,
adjustment of the PNP switch or
the shift cable may be incorrect.
↑
↑
Specified Condition
10 to 14 V
Specified Condition
10 to 14 V