Toyota 2GR-FE Manual page 147

EM–146
EM
14 mm
(0.55 in.)
13 mm
(0.51 in.)
A
2GR-FE ENGINE MECHANICAL – ENGINE UNIT
(j)
A129673
49. INSTALL FRONT ENGINE MOUNTING BRACKET NO.
Stud Bolt
1 LH
(a) Install the engine mounting bracket with the 6 bolts.
(b) When replacing a stud bolt, install it by using an E8
29 mm
(1.14 in.)
A134961E01
50. INSTALL OIL PAN BAFFLE PLATE
(a) Install the oil pan baffle plate with the 7 bolts.
A
A129685E01
Install the water inlet with the 2 nuts.
Torque: 10 N*m (102 kgf*cm, 7 ft.*lbf)
Torque: 54 N*m (551 kgf*cm, 40 ft.*lbf)
NOTICE:
• Install the water inlet and mounting bracket
within 15 minutes after installing the chain
cover.
• Do not start the engine for at least 2 hours
after installation.
"torx" socket wrench.
Torque: 10 N*m (102 kgf*cm, 7 ft.*lbf)
Torque: 10 N*m (102 kgf*cm, 7 ft.*lbf)
HINT:
Temporarily tighten the 7 bolts. Fully tighten 2 bolts
A as shown in the illustration before tightening the
other bolts.