Toyota 2GR-FE Manual page 152

7
2
6
1
5
A
10 12
11
Nut
Nut
SST
Hold
Turn
SST
2GR-FE ENGINE MECHANICAL – ENGINE UNIT
(d) Install the head cover with the 12 bolts and a new
8
9
3
4
A129678E03
57. INSTALL WATER OUTLET
(a) Install 2 new gaskets and a new O-ring.
A129677
(b) Install the water by-pass joint with the 2 bolts and 4
Nut
Nut
58. INSTALL CRANKSHAFT PULLEY
(a) Align the pulley set key with the key groove of the
A129676E01
(b) Using SST, install the pulley bolt.
A122396E01
washer.
Torque: 21 N*m (214 kgf*cm, 15 ft.*lbf) for bolt A
10 N*m (102 kgf*cm, 7 ft.*lbf) for bolts
except A
HINT:
Make sure the tightening torque of bolts 1 and 10.
HINT:
Apply soapy water to the O-ring.
nuts.
Torque: 10 N*m (102 kgf*cm, 7 ft.*lbf) for bolts
10 N*m (103 kgf*cm, 7 ft.*lbf) for nuts
NOTICE:
Be careful that the O-ring does not get caught
between the parts.
pulley, and slide on the pulley.
SST 09213-70011 (09213-70020), 09330-00021
Torque: 250 N*m (2,550 kgf*cm, 184 ft.*lbf)
EM–151
EM