Toyota 2GR-FE Manual page 141

EM–140
Timing Marks
EM
SST
A
A
2GR-FE ENGINE MECHANICAL – ENGINE UNIT
Timing Marks
Center Line
Timing Mark
A134895E01
A125109E04
A132227E03
(d) Remove the hexagon wrench of the chain tensioner.
Check that each timing mark is aligned with the
crankshaft at the TDC / compression.
(e) Remove the pulley set bolt.
45. INSTALL TIMING CHAIN CASE OIL SEAL
(a) Using SST, tap in a new oil seal until its surface is
flush with the timing gear case edge.
SST 09223-22010, 09506-35010
NOTICE:
• Keep the lip free of foreign matter.
• Do not tap on the oil seal at an angle.
• Make sure that the oil seal edge does not
stick out of the timing chain case.
46. INSTALL WATER PUMP ASSEMBLY
(a) Install a new gasket and the water pump with the 8
bolts.
Torque: 9.1 N*m (93 kgf*cm, 81 in.*lbf)
NOTICE:
Be sure to replace the bolts indicated by A with
new ones or reuse them after applying adhesive
1344.