Toyota 2GR-FE Manual page 689

2GR-FE ENGINE CONTROL SYSTEM – ACCELERATOR PEDAL
Intelligent Tester
DLC3
CAN VIM
ON-VEHICLE INSPECTION
1. CHECK ACCELERATOR PEDAL ROD
(a) Measure the voltage.
(1) Connect the intelligent tester to the DLC3.
(2) Turn the ignition switch on (IG).
(3) Turn the intelligent tester ON.
(4) Select the menu items: DIAGNOSIS /
ENHANCED OBD II / DATA LIST / ALL /
ACCEL POS #1, ACCEL POS #2.
(5) Operate the accelerator pedal, and then check
that the ACCEL POS #1 and ACCEL POS #2
values are within the specifications.
Standard voltage (ACCEL POS #1)
Accelerator Pedal Condition
B127989E01
Released
Depressed
Standard voltage (ACCEL POS #2)
Accelerator Pedal Condition
Released
Depressed
If the result is not as specified, check the
accelerator pedal rod, wire harness or ECM.
REMOVAL
1. REMOVE ACCELERATOR PEDAL
(a) Disconnect the accelerator pedal connector.
(b) Remove the 2 bolts and the accelerator pedal
assembly.
A135676
ES–521
Specified Condition
0.5 to 1.1 V
2.5 to 4.5 V
Specified Condition
1.2 to 2.0 V
3.4 to 5.0 V
ES