Toyota 2GR-FE Manual page 679

2GR-FE ENGINE CONTROL SYSTEM – KNOCK SENSOR
RH Bank :
LH Bank :
Front
21. REMOVE KNOCK CONTROL SENSOR
(a) Disconnect the 2 knock control sensor connectors.
(b) Remove the 2 bolts and 2 knock control sensors.
A129615
INSPECTION
1. INSPECT KNOCK CONTROL SENSOR
(a) Using an ohmmeter, measure the resistance
between the terminals.
Standard resistance:
120 to 280 kΩ at 20°C (68°F)
If the result is not as specified, replace the sensor.
A065174
INSTALLATION
1. INSTALL KNOCK CONTROL SENSOR
5
(a) Install the 2 knock control sensors with the 2 bolts
10
as shown in the illustration.
Torque: 20 N*m (204 kgf*cm, 15 ft.*lbf)
(b) Connect the 2 knock control sensor connectors.
10
2. INSTALL INTAKE MANIFOLD (See page EM-41)
5
3. CONNECT FUEL TUBE SUB-ASSEMBLY (See page
EM-46)
4. INSTALL INTAKE AIR SURGE TANK (See page
18)
5. INSTALL NO. 1 AIR CLEANER INLET (See page
49)
6. INSTALL AIR CLEANER CASE SUB-ASSEMBLY (See
page EM-50)
7. INSTALL AIR CLEANER CAP SUB-ASSEMBLY (See
page ES-506)
A132951E01
8. INSTALL AIR CLEANER INLET ASSEMBLY (See page
EM-50)
9. INSTALL V-BANK COVER SUB-ASSEMBLY (See
page EM-52)
10. INSTALL COOL AIR INTAKE DUCT SEAL (See page
EM-52)
11. INSTALL COWL TOP PANEL OUTER SUB-
ASSEMBLY (See page ES-485)
12. INSTALL WINDSHIELD WIPER MOTOR AND LINK
(See page WW-14)
ES–511
ES
FU-
EM-