Toyota 2GR-FE Manual page 859

SST (A)
SST (B)
SST (A)
Rotor Shaft
Clutch Pulley
SST (B)
2GR-FE CHARGING – GENERATOR
5. INSTALL GENERATOR TERMINAL INSULATOR
(a) Install the terminal insulator to the generator coil.
NOTICE:
Pay attention to installation direction of the
terminal insulator.
A128083E01
6. INSTALL GENERATOR REAR END COVER
(a) Install the generator rear end cover to the generator
coil with the 3 nuts.
Torque: 4.6 N*m (47 kgf*cm, 41 in.*lbf)
7. REMOVE GENERATOR CLUTCH PULLEY
(a) Temporarily install the clutch pulley onto the rotor
shaft.
A128071
(b) Set SST (A) and (B).
SST
A128084E01
(c) Clamp SST (A) in a vise.
(d) Place the rotor shaft end into SST (A).
SST (B)
A135194E01
(e) Fit SST (B) to the clutch pulley.
SST (B)
A135195E01
09820-63020
CH–21
CH