Toyota 2GR-FE Manual page 836

2GR-FE LUBRICATION – OIL PUMP
Bolt length
Item
Bolt A
Bolt B
Bolt C
NOTICE:
Make sure that there is no oil on the bolt
threads.
(f) Fully tighten the bolts in this order: Area 1 and Area
2.
Torque: 21 N*m (214 kgf*cm, 15 ft.*lbf)
(g) Fully tighten the bolts and nuts in this order: Area 3.
Torque: 21 N*m (214 kgf*cm, 15 ft.*lbf)
HINT:
Tighten the bolts and nuts in the order of upper to
lower as shown in the illustration.
(h) Fully tighten the bolts in this order: Area 4.
Torque: Bolt A
HINT:
Tighten the bolts in the order of lower to upper as
shown in the illustration.
3. INSTALL CYLINDER HEAD COVER SUB-ASSEMBLY
(for Bank 2) (See page EM-150)
4. INSTALL WATER INLET HOUSING (See page EM-144)
5. REMOVE NO. 1 ENGINE MOUNTING BRACKET
FRONT LH (See page EM-38)
6. INSTALL OIL PAN SUB-ASSEMBLY (See page
147)
7. INSTALL OIL STRAINER SUB-ASSEMBLY (See page
EM-148)
8. INSTALL NO. 2 OIL PAN SUB-ASSEMBLY (See page
EM-148)
9. INSTALL CYLINDER HEAD COVER SUB-ASSEMBLY
(for Bank 1) (See page EM-149)
10. INSTALL CYLINDER HEAD COVER SUB-ASSEMBLY
(for Bank 2) (See page EM-150)
11. INSTALL CRANKSHAFT PULLEY (See page EM-151)
12. INSTALL NO. 1 OIL PIPE (See page EM-153)
13. INSTALL OIL PIPE (See page EM-153)
14. INSTALL NO. 1 VACUUM SWITCHING VALVE (See
page EC-14)
15. INSTALL RADIO SETTING CONDENSER (See page
EM-38)
16. INSTALL WATER PUMP PULLEY (See page CO-10)
40 mm (1.57 in.)
55 mm (2.17 in.)
25 mm (0.98 in.)
43 N*m (438 kgf*cm, 32 ft.*lbf)
Except bolt A
21 N*m (214 kgf*cm, 15 ft.*lbf)
LU–19
Length
EM-
LU