Toyota 2GR-FE Manual page 139

EM–138
Turn
EM
When the idle sprocket is reused:
Mark
Align
Chain Plate
2GR-FE ENGINE MECHANICAL – ENGINE UNIT
A134890
A122184E04
Mark Plate
Timing Marks
A132224E01
(b) Do not pass the chain over the crankshaft, just put it
on it.
(c) Turn the camshaft timing gear assembly on the RH
bank counterclockwise to tighten the chain between
the banks.
NOTICE:
When the idle sprocket is reused, align the chain
plate with the mark where the plate had been in
order to tighten the chain between the banks.
(d) Align the mark plate and timing mark as shown in
the illustration and install the chain onto the
crankshaft timing sprocket.
HINT:
The crankshaft mark plate is yellow.
(e) Temporarily tighten the pulley set bolt.