Toyota 2GR-FE Manual page 30

2GR-FE ENGINE MECHANICAL – ENGINE ASSEMBLY
44. DISCONNECT FRONT STABILIZER LINK ASSEMBLY
RH
HINT:
Use the same procedures described for the LH side.
45. DISCONNECT FRONT SPEED SENSOR LH (See page
DS-7)
46. DISCONNECT FRONT SPEED SENSOR RH
HINT:
Use the same procedures described for the LH side.
47. DISCONNECT TIE ROD ASSEMBLY LH (See page
DS-8)
48. DISCONNECT TIE ROD ASSEMBLY RH
HINT:
Use the same procedures described for the LH side.
49. DISCONNECT FRONT SUSPENSION LOWER NO. 1
ARM LH (See page DS-8)
50. DISCONNECT FRONT SUSPENSION LOWER NO. 1
ARM RH
HINT:
Use the same procedures described for the LH side.
51. SEPARATE FRONT AXLE ASSEMBLY LH (See page
DS-8)
52. SEPARATE FRONT AXLE ASSEMBLY RH
HINT:
Use the same procedures described for the LH side.
53. REMOVE NO. 1 EXHAUST PIPE SUPPORT BRACKET
(a) Remove the No. 1 exhaust pipe support bracket
54. REMOVE DRIVE PLATE AND TORQUE CONVERTER
CLUTCH SETTING BOLT (See page AX-211)
55. DISCONNECT STEERING SLIDING YOKE (See page
PS-40)
56. REMOVE GENERATOR ASSEMBLY (See page CH-14)
57. SEPARATE COOLER COMPRESSOR ASSEMBLY
(a) Remove the 2 connector clamps.
(b) Remove the 4 bolts and separate the compressor.
58. REMOVE ENGINE ASSEMBLY WITH TRANSAXLE
(a) Set the engine lifter.
A132977
with the 2 bolts.
HINT:
Hang up the hoses instead of detaching them.
EM–29
EM