ES–70
ES
Intelligent Tester Display
EVAP SYS CHECK
(AUTO OPERATION)
EVAP SYS CHECK
(MANUAL OPERATION)
2GR-FE ENGINE CONTROL SYSTEM – SFI SYSTEM
3.
SYSTEM CHECK
HINT:
Performing a SYSTEM CHECK enables the system,
which consists of multiple actuators, to be operated
without removing any parts. In addition, it can show
whether or not any DTCs are set, and can detect
potential malfunctions in the system. The SYSTEM
CHECK can be performed with an intelligent tester.
(a) Connect the intelligent tester to the DLC3.
(b) Turn the ignition switch on (IG).
(c) Turn the tester on.
(d) Enter the following menus: DIAGNOSIS /
(e) Perform the SYSTEM CHECK by referring to the
Test Detail
Perform 4 steps in order to
operate EVAP key-off monitor
automatically
Perform 4 steps in order to
operate EVAP key-off monitor
automatically
ENHANCED OBD II / SYSTEM CHECK.
table below.
Recommended Fuel
Temperature
35°C (95°F) or less
35°C (95°F) or less
Diagnostic Note
•
If no DTCs are in PENDING
CODE after performing this
test, system is functioning
normally
•
Refer to EVAP system
•
Used to detect malfunctioning
parts
•
Refer to EVAP system