Toyota 2GR-FE Manual page 751

FU–38
FU
Pinch
Pull
Pull
Fuel Tube Connector
O-Ring
2GR-FE FUEL – FUEL TANK
A136008E01
A135224
Clip
A135225E01
Retainer
Pinch
Retainer
Pipe
A121573E02
14. REMOVE REAR STABILIZER BAR NO. 1 BRACKET
(a) Remove the 4 bolts and 2 rear stabilizer bar No. 1
brackets.
15. REMOVE FUEL TANK PROTECTOR LOWER CENTER
(a) Remove the 4 bolts and fuel tank protector (Except
SE Grade).
(b) Remove the 4 bolts and 2 clips (for SE Grade).
(c) Remove the fuel tank protector (for SE Grade).
16. REMOVE FUEL TANK ASSEMBLY
(a) Disconnect the fuel pump tube.
(1) Pinch the tab of the retainer to disengage the
lock claws and pull it down as shown in the
illustration.
(2) Pull out the fuel tank main tube.
NOTICE:
• Check that there is no dirt or other
foreign objects around the connector
before this operation and clean the
connector if necessary.
• It is necessary to prevent mud or dirt
from entering the quick connector. If mud
enters the connector, the O-rings may
not seal properly.
• Remove the quick connector by hand.
• Do not bend or twist the nylon tube.
Protect the connector by covering it with
a plastic bag.