Toyota 2GR-FE Manual page 853

SST (A)
SST (B)
SST (A)
Rotor Shaft
Clutch Pulley
SST (B)
2GR-FE CHARGING – GENERATOR
DISASSEMBLY
1. REMOVE GENERATOR CLUTCH PULLEY
(a) Using a screwdriver, remove the generator pulley
cap.
A128068E01
(b) Set SST (A) and (B).
SST
(c) Clamp SST (A) in a vise.
A128069E01
(d) Place the rotor shaft end into SST (A).
SST (B)
A135194E01
(e) Fit SST (B) to the clutch pulley.
SST (B)
A135195E01
(f) Loosen the pulley by turning SST (B) in the direction
shown in the illustration.
(g) Remove the generator assembly from the SST.
(h) Remove the clutch pulley from the rotor shaft.
SST (B)
A135196E01
09820-63020
CH–15
CH