Toyota 2GR-FE Manual page 699

Pinch A
Pinch A
Push
Pinch
Push
Pinch
2GR-FE EMISSION CONTROL – CANISTER
REMOVAL
1. REMOVE FUEL TANK ASSEMBLY
HINT:
(See page FU-36)
2. REMOVE CHARCOAL CANISTER ASSEMBLY
(a) Disconnect the fuel tank vent hose from the
charcoal canister.
(1) Push the connector deep inside.
A
(2) Pinch portion A.
(3) Pull out the connector.
A
A132954E01
(b) Disconnect the charcoal canister filter sub-assembly
from the charcoal canister.
(1) Push the connector deep inside.
A
(2) Pinch portion A.
(3) Pull out the connector.
(c) Disconnect the vapor pressure sensor connector.
(d) Disconnect the wire harness clamp.
A
(e) Disconnect the purge line hose from the charcoal
canister.
A128095E01
(f) Remove the 2 bolts, clip and charcoal canister.
A128096
INSPECTION
1. INSPECT CHARCOAL CANISTER ASSEMBLY
(a) Visually check the charcoal canister for cracks or
damage.
If cracks or damage are found, replace the charcoal
canister assembly.
A128097
EC–9
EC