Toyota 2GR-FE Manual page 153

EM–152
Oil Filter
Element
SST
EM
Adhesive
2GR-FE ENGINE MECHANICAL – ENGINE UNIT
59. INSTALL OIL FILTER ELEMENT
O-Ring
A106167E01
No clearance
A132239E01
O-Ring
A128003E02
60. INSTALL CYLINDER BLOCK WATER DRAIN COCK
A076531E01
(a) Clean the inside of the oil filter cap, the threads and
O-ring groove.
(b) Apply a light coat of engine oil to a new O-ring and
install it to the oil filter cap.
(c) Set a new oil filter element to the oil filter cap.
(d) Remove dirt or foreign matter from the installation
surface of the engine.
(e) Apply a light coat of engine oil to the O-ring again
and install the oil filter cap.
NOTICE:
• Be careful that the O-ring does not get caught
between the parts.
• The O-ring must not be twisted on the groove.
(f) Using SST, tighten the oil filter cap.
SST 09228-06501
Torque: 25 N*m (255 kgf*cm, 18 ft.*lbf)
NOTICE:
Make sure that the oil filter is installed securely
as shown in the illustration.
(g) Apply a light coat of engine oil to a new O-ring and
install it to the oil filter cap.
NOTICE:
Remove all dirt and foreign matter from the
installation surface.
(h) Install the oil filter drain plug to the oil filter cap.
Torque: 13 N*m (130 kgf*cm, 9 ft.*lbf)
NOTICE:
Make sure that the O-ring does not get caught
between the parts.
SUB-ASSEMBLY
(a) Apply adhesive around the drain cocks.
Adhesive:
Toyota Genuine Adhesive 1324, Three Bond
1324 or Equivalent