Toyota 2GR-FE Manual page 687

2GR-FE ENGINE CONTROL SYSTEM – ECM
(c) Remove the 4 screws and 2 ECM brackets.
A135713
INSTALLATION
1. INSTALL ECM
(a) Install the ECM bracket with the 4 screws.
Torque: 3.0 N*m (31 kgf*cm, 27 in.*lbf)
(b) Connect the 2 ECM connectors.
NOTICE:
When connecting the connector, make sure that
dirt, water and other foreign matter do not
become stuck between the connector and other
A135713
parts.
(1) Connect the 2 ECM connectors and lower the 2
A128949
(c) Install the ECM with the 3 nuts.
Torque: 8.0 N*m (82 kgf*cm, 71 in.*lbf)
2. INSTALL COWL TOP PANEL OUTER SUB-
ASSEMBLY (See page ES-485)
3. INSTALL WINDSHIELD WIPER MOTOR AND LINK
(See page WW-14)
4. INSTALL COWL TOP VENTILATOR LOUVER SUB-
ASSEMBLY (See page WW-15)
5. INSTALL FRONT FENDER TO COWL SIDE SEAL RH
(See page WW-15)
6. INSTALL FRONT FENDER TO COWL SIDE SEAL LH
(See page WW-15)
7. INSTALL WINDSHIELD WIPER ARM AND BLADE
A135711
ASSEMBLY LH (See page WW-15)
8. INSTALL WINDSHIELD WIPER ARM AND BLADE
ASSEMBLY RH (See page WW-16)
9. CONNECT CABLE TO NEGATIVE BATTERY
TERMINAL (See page EM-51)
levers.
NOTICE:
Make sure that the 2 levers are securely
lowered.
ES–519
ES