Toyota 2GR-FE Manual page 127

EM–126
RH Bank:
EM
Gray
Intake Side
SST
CORRECT
2GR-FE ENGINE MECHANICAL – ENGINE UNIT
17. INSTALL STRAIGHT PIN
LH Bank:
18. INSTALL VALVE SPRING SEAT
19. INSTALL VALVE STEM OIL SEAL
Black
Exhaust Side
A094934E04
INCORRECT
A124592E02
(a) Using a plastic hammer, tap in new straight pins as
shown in the illustration.
34 mm
(1.34 in.)
Protrusion height:
17.5 to 19.5 mm (0.689 to 0.768 in.)
(a) Install the valve spring seats to the cylinder head.
(a) Apply a light coat of engine oil to new oil seals.
NOTICE:
Pay attention when installing the intake and
exhaust oil seals. For example, installing the
intake oil seal into the exhaust side or installing
the exhaust oil seal to the intake side can cause
installation problems later.
HINT:
The intake valve oil seals are gray and the exhaust
valve oil seals are black.
(b) Using SST, push in the oil seals.
SST 09201-41020
NOTICE:
Failure to use SST will cause the seal to be
damaged or improperly seated.
17.5 to 19.5 mm
(0.69 to 0.77 in.)
A131890E01