Toyota 2GR-FE Manual page 971

19
INSPECT ENGINE ROOM RELAY BLOCK (ST RELAY VOLTAGE)
Engine Room R/B
ST Relay Terminal
OK
20
INSPECT STARTER ASSEMBLY
OK
REPAIR OR REPLACE HARNESS OR CONNECTOR (PNP SWITCH - ST RELAY, STARTER -
BATTERY)
21
READ VALUE OF INTELLIGENT TESTER (L CODE)
2GR-FE STARTING – SMART KEY SYSTEM
(a) Measure the voltage according to the value(s) in the
table below.
Standard voltage
Tester Connection
ST relay terminal - 5 -
Body ground
NG
B138012E01
HINT:
See page ST-143.
NG
(a) Reconnect the connectors.
(b) Connect the intelligent tester to the DLC3.
HINT:
When using the intelligent tester with the engine switch
off, turn on and off any of the door courtesy light switches
repeatedly at 1.5 second intervals or less until
communication between the tester and vehicle starts.
Condition
Always
REPAIR OR REPLACE HARNESS OR
CONNECTOR
REPAIR OR REPLACE STARTER ASSEMBLY
ST–109
Specified Condition
9 to 14 V
ST