Toyota 2GR-FE Manual page 437

OK
4
REPLACE ECM
NEXT
5
CHECK WHETHER DTC OUTPUT RECURS (AFTER REPAIR)
NEXT
COMPLETED
2GR-FE ENGINE CONTROL SYSTEM – SFI SYSTEM
(a) Replace the ECM (See page ES-518).
(a) Connect the intelligent tester to the DLC3.
(b) Turn the ignition switch on (IG) (do not start the engine).
(c) Turn the tester on.
(d) Wait for at least 60 seconds.
(e) Enter the following menus: DIAGNOSIS / ENHANCED
OBD II / DTC INFO / PENDING CODES.
HINT:
If no pending DTCs are displayed on the tester, the
repair has been successfully completed.
ES–281
ES