Toyota 2GR-FE Manual page 927

DTC B2282
DESCRIPTION
The main body ECU and the combination meter are connected by a cable and the CAN. DTC B2282 is
output when: 1) the cable information and CAN information are inconsistent; and 2) a malfunction is
detected between the vehicle speed sensor and combination meter.
HINT:
When the main body ECU is replaced with a new one and the negative (-) battery terminal is connected,
the power source mode becomes the IG-ON mode. When the battery is removed and reinstalled, the
power source mode that was selected when the battery was removed is restored.
After the main body ECU is replaced, perform the registration procedures for the engine immobiliser
system (See page EI-8).
DTC No.
When both conditions below are met:
•
B2282
•
Skid Control ECU
Front
Speed
Sensor
2GR-FE STARTING – SMART KEY SYSTEM
Vehicle Speed Signal Malfunction
DTC Detection Condition
Cable information and CAN information between
the main body ECU and the combination meter are
inconsistent
Malfunction is detected between the vehicle speed
sensor and the combination meter
Combination
Meter (Meter
4 pulses
ECU)
B2283 Detection Area
Trouble Area
• CAN communication system
• Combination meter system
• Main body ECU
• Wire harness or connector
4 pulses
Main Body ECU
CAN
B2282 Detection Area
ST–65
A109248E08
ST