Toyota 2GR-FE Manual page 774

Water Hose
Water Inlet Housing
Drain Hole
C
B
A
A
C
A A
A
A
2GR-FE COOLING – WATER PUMP
7. REMOVE WATER INLET HOUSING
(a) Disconnect the water hose.
(b) Remove the 2 bolts, nut and water inlet housing.
A133375E01
(c) Remove the water inlet housing gasket and water
A128120
8. REMOVE WATER PUMP ASSEMBLY
(a) Remove the 16 bolts, water pump assembly and
A094889
INSPECTION
Air Hole
1. INSPECT WATER PUMP ASSEMBLY
(a) Visually check the drain hole and air hole for coolant
(b) Turn the pulley, and check that the water pump
A096655E06
INSTALLATION
B
1. INSTALL WATER PUMP ASSEMBLY
B B
(a) Install a new water pump gasket and the water
A
B
A
A
A128115E01
outlet pipe O-ring.
water pump gasket.
leakage.
bearing moves smoothly and noiselessly.
If the bearing does not move smoothly and
noiselessly, replace the water pump.
pump assembly with the 16 bolts.
Torque: Bolt A
21 N*m (214 kgf*cm, 15 ft.*lbf)
Bolts B and C
9.1 N*m (93 kgf*cm, 81 in.*lbf)
NOTICE:
• Make sure that there is no oil on the threads
of bolts A.
CO–9
CO