Toyota 2GR-FE Manual page 857

Diameter
SST
Tab
Cutout
2GR-FE CHARGING – GENERATOR
(d) Using vernier calipers, measure the slip ring
diameter.
Standard diameter:
14.2 to 14.4 mm (0.559 to 0.567 in.)
Minimum diameter:
14.0 mm (0.551 in.)
If the diameter is less than the minimum, replace the
generator rotor assembly.
A124106E01
4. INSPECT GENERATOR DRIVE END FRAME
BEARING
(a) Check that the drive end frame bearing is not rough
or worn.
If necessary, replace the drive end frame bearing.
A128080
REASSEMBLY
1. INSTALL GENERATOR DRIVE END FRAME
BEARING
(a) Using SST and a press, press in a new generator
drive end frame bearing.
SST
A128081E01
(b) Fit the tabs on the retainer plate into the cutouts on
the drive end frame to install the retainer plate.
(c) Install the 4 screws.
Torque: 2.3 N*m (23 kgf*cm, 20 in.*lbf)
2. INSTALL GENERATOR ROTOR ASSEMBLY
(a) Place the drive end frame on the clutch pulley.
A137712E01
(b) Install the generator rotor assembly to the drive end
frame.
A118367E01
09950-60010 (09951-00470), 09950-70010
(09951-07100)
CH–19
CH