Toyota 2GR-FE Manual page 879

A
5
CHECK FOR DTC
A
6
INSPECT BASIC OPERATION
NEXT
7
PROBLEM SYMPTOMS TABLE
Result
Result
Fault is not listed in the problem symptoms table
Fault is listed in the problem symptoms table
2GR-FE STARTING – SMART KEY SYSTEM
Result
CAN DTC is not output
CAN DTC is output
B
(a) Check for DTCs and note any codes that are output (See
page ST-26).
(b) Delete DTCs.
(c) Recheck for DTCs.
Result
DTC does not reoccur
DTC reoccurs
B
(a) Turn the engine switch on (START) and check that the
engine starts normally. Make sure the brake pedal is
depressed and the shift position is P at this time.
(b) Check that the engine switch mode can be changed by
pushing the engine switch.
HINT:
Without depressing the brake pedal, push the engine
switch repeatedly. Engine switch mode should turn from
off to on (ACC) to on (IG) and back to off.
With the brake pedal depressed, push the engine switch
repeatedly. Engine switch mode should turn to ENGINE
START from any status.
OK:
Engine can start normally.
Result
GO TO CAN COMMUNICATION SYSTEM
Result
GO TO DIAGNOSTIC TROUBLE CODE
CHART
Proceed to
A
B
ST–17
Proceed to
A
B
Proceed to
A
B
ST