Shut Down Definity Audix System (If Necessary); Replace Circuit Packs - Avaya CMC1 Installation, Upgrades And Additions

Upgrading R6csi/R7csi/R8csi to Avaya MultiVantage
Software on an Avaya DEFINITY Server CSI
2. If administered recorded announcements are listed, type save
announcements UUCSS and press
about 30 minutes.
Shut Down DEFINITY AUDIX System (if
necessary)
!
WARNING:
Neglecting to shut down the AUDIX assembly before powering down the
system cabinet where it resides can damage the AUDIX disk.
1. Shut down the AUDIX assembly and allow the disk to completely spin
down. Refer to
!
CAUTION:
If leaving AUDIX System in the carrier, back it out about 2 in. (5 cm) to
eliminate the possibility of damage due to power surges.

Replace Circuit Packs

!
CAUTION:
When working with any cabinet hardware, wear a grounded wrist strap to
ground yourself against electrostatic discharge (ESD).
1. Pull out the TN798 processor to power down the cabinet.
2. Insert the Avaya MultiVantage Software media (orange card) into the new
TN2402 processor circuit pack slot.
3. Place the TN2402 processor circuit pack into the slot vacated by the
TN798 processor.
4. Lock the TN2402 processor into place to power up the cabinet.
The system reads the Avaya MultiVantage Software automatically.
5. Install the original translation card when the system prompts (beeps)
3-16
Issue 5 October 2002
NOTE:
For some DEFINITY ECS software versions, type save
announcements from UUCSS. Type help and press
complete command syntax.
''DEFINITY AUDIX Power Procedures'' on page
NOTE:
In most cases the orange card will not be on-site and the upgrade
performed using the pre-loaded MultiVantage Software on the
TN2402 Processor circuit pack. If this is true, skip to Step 7.
. For example, 01D03. This takes
Enter
for
Enter
3-27.
555-233-118