Accessing The Cli Via A Modem Connection To The S8300; Accessing Avaya Iw - Avaya G450 Manual

Accessing the Avaya G450 Media Gateway

Accessing the CLI via a modem connection to the S8300

If the Avaya G450 Media Gateway includes an S8300 Server, you can access the CLI from a
remote location. This is done by establishing a PPP network connection from a modem at the
remote location to a USB modem connected to one of the USB ports on the front panel of the
S8300. The G450 supports the Multitech MultiModem USB, MT5634ZBA-USB-V92.
Note:
In order to access the CLI via the S8300, the PMI of the G450 must be
Note:
configured. See
page 80.
1. Connect a USB modem to either of the two USB ports on the Avaya S8300 Server.
2. Use the Avaya Maintenance Web Interface (MWI) to configure the USB port on the S8300
for modem use. For instructions, see Installing and Upgrading the Avaya G450 Media
Gateway, 03-602054.
3. From a remote computer, create a dialup network connection to the S8300. Use the
TCP/IP and PPP protocols to create the connection.
4. Open any standard telnet program on the remote computer.
5. Enter the command telnet, followed by the IP address of the S8300 USB port to which
the modem is connected.
6. Enter the command telnet, followed by the PMI of the G450.

Accessing Avaya IW

The Avaya Installation Wizard (Avaya IW) is a web-based installation wizard that is used with
the Avaya G450 Media Gateway to perform initial configuration tasks and to upgrade software
and firmware. The Avaya IW is designed for use with systems that include an S8300 Server,
operating in either ICC or LSP mode. See
page 82.
Specifically, you can perform the following tasks with the Avaya IW:
Configure PMI and SNMP information, Ethernet interfaces, primary and secondary Media
●
Gateway Controllers, G450 telephony and trunk parameters, and alarms
Install license and password files, software, and firmware upgrades
●
Enable and configure the USB ports of the S8300 and G450 for modem use
●
Change your password
●
48 Administration for the Avaya G450 Media Gateway
Configuring the Primary Management Interface (PMI)
Configuring the Media Gateway Controller (MGC)
on
on