Checking Juniper Firmware Compatibility - Avaya IG550 Installing And Configuring

Installing an IG550 Integrated Gateway using the Disk on Key
Note:
On J-series Services Routers, you cannot use a USB memory stick that provides
Note:
U3 features (such as the U3 Titanium device from SanDisk Corporation) as the
media device during system boot. You must remove the U3 support before using
the device as external media. For the U3 Titanium device, you can use the U3
Launchpad Removal Tool on a Windows-based system to remove the U3
features. The tool is available for download at
Default.aspx?CatID=1415. To restore the U3 features, you can use the U3
Launchpad Installer Tool accessible at
Default.aspx?CatID=1411.

Checking Juniper firmware compatibility

The software for the J-series router must be release 8.4 or higher. If it is not, upgrade the router
software to release 8.4 before continuing with the installation. See the Juniper J2320, J2350,
J4350, and J6350 Services Router Getting Started Guide, Release 8.4.
!
CAUTION:
Neither the Telephony Interface Modules (TIMs) nor the TGM550 should be
CAUTION:
inserted into the J-series router before you are sure the router is running release
8.4 or higher. Failure to comply with this caution may cause your system to
become inoperable.
Also, check what Juniper software is compatible with the specific TGM550 firmware load you
are downloading. You might need to install newer router firmware before you install new
TGM550 firmware.
1. Go to http://support.avaya.com, and select Communication Manager from the most
popular documents list or by searching by product name.
2. Search All Documents for Communication Manager Software & Firmware Compatibility
Matrix.
12 Installing and Configuring the IG550 Integrated Gateway
http://www.sandisk.com/Retail/
http://www.sandisk.com/Retail/