Verifying The Contents Of The Tftpboot Directory; Determining Which Firmware To Install On The G700 - Avaya G700 Installation Manual
Media gateway and media server
Hide thumbs
Also See for G700:
- Installing and upgrading (808 pages) ,
- Installing manual (768 pages) ,
- Installation and upgrades (734 pages)
Table of Contents
Advertisement
Installing new firmware on the media modules
Installing IA770 update (patch) files, if any
Verifying the Contents of the tftpboot Directory
Before proceeding with the G700 firmware installation, you should check the /tftpboot directory
on the TFTP server to make sure the firmware versions match those listed in the planning
documentation. If they do not, you must copy the correct firmware versions into the /tftpboot
directory using the following procedure:
1. Download the firmware files from the support Website to your laptop.
2. Using the Web Interface on the S8300 Media Server, copy the firmware files from your
laptop to the /var/home/ftp/pub directory on the S8300, or
Alternatively, you can "ftp" the files from your laptop to the pub directory.
3. Copy the firmware files from the pub directory to the /tftpboot directory, using the S8300
Media Server command line interface.
Note:
For detailed information on this procedure, see "Appendix 2" in Job Aid:
Note:
Replacing the G700 Media Gateway, 555-245-752, Issue 4, January, 2005.
Determining which firmware to install on the G700
Conduct the following procedure to compare software versions running on the G700 processors
and media modules with the versions in you planning documents. If the versions do not match,
you need to install the new firmware for those components.
To determine if new firmware for the P330 stack processor is necessary
1. At either the P330-1(super)# or P330-1(configure)# prompt, type dir.
The system displays the directory list of software for the P330 stack processor.
Directory list for P300 stack processor
M# file
-- ----
1
module-config
Configuration
1
stack-config
1
EW_Archive
1
Booter_Image
ver num
file type
-------
----------
N/A
Running Conf
N/A
Running Conf
4.0.4
SW Web Image
3.2.5
SW BootImage
Install New Firmware on the G700
file location
file description
-------------
----------------
Ram
Module
Ram
Stack Configuration
NV-Ram
WEB Download
NV-Ram
Booter Image
Issue 7 January 2005
161
Advertisement
Table of Contents
