Installing the Avaya G350 Media Gateway
Placing the G350 on a table
If you will be installing the G350 as a tabletop unit, you need to affix the provided rubber feet to
the underside of the G350.
To affix the feet:
1. Remove the four feet from their packaging.
2. Turn the G350 upside down.
3. Position each foot into one of the mounting sites, near each corner of the chassis.
4. Press the plastic rivet into the foot with a stylus until it is firmly seated on the chassis.
Step 2: Install the media modules
Note:
The required media modules are usually pre-installed in the G350 chassis. If this
Note:
is the case, skip this step. Read this section only if the media modules are not
pre-installed, or if you want to replace modules or add new media modules.
When the G350 chassis is installed, you can insert the media modules. Each module is shipped
with two thumb screws for securing the position of the module in the G350 chassis.
Before inserting media modules into the G350 chassis, make sure:
Not to install an unsupported combination of media modules. See
●
To allocate a permissible slot to each media module. See
●
To install an S8300 media module, see
To install each of the other media modules, see
!
WARNING:
The Avaya G350 Media Gateway must not be operated with any open slots.
WARNING:
Failure to cover empty slots with the supplied blank plates can cause overheating
due to inadequate air distribution.
34 Installation and Upgrades for the Avaya G350 Media Gateway
Inserting the S8300 Media Server module
Inserting media modules
Combination
Allocating slots
on page 35.
on page 37.
on page 39.
limitations.