Installing the Avaya G250 Media Gateway
Step 2: Install the media modules
When the G250 chassis is installed, you can insert the media modules. Each module is shipped
with two thumb screws for securing the position of the module in the G250 chassis.
Before inserting media modules into the G250 chassis, make sure:
Not to install an unsupported media module. See
●
To allocate a permissible slot to each media module. See
●
To install an S8300B media module, see
page 35.
To install each of the other media modules, see
!
WARNING:
The Avaya G250 Media Gateway must not be operated with any open slots.
WARNING:
Failure to cover empty slots with the supplied blank plates can cause overheating
due to inadequate air distribution.
Supported Modules
The G250 does not support all Media Modules. Before you insert other Media Modules, review
the following list for combination limitations.
The Avaya G250 Media Gateway supports the following modules only:
S8300B Media Gateway in slot V1
●
MM340 in slot V2
●
MM342 in slot V2
●
Allocating slots
You insert media modules into the slots marked V1 and V2 on the G250 front panel, shown in
Figure 4
below.
Tip:
The slot positions and names are the same on the G250 and the G250-BRI.
Tip:
34 Installation and Upgrade for the Avaya G250 Media Gateway
Supported
Inserting the S8300B Media Server module
Inserting media modules
Modules.
Allocating slots
on page 34.
on page 37.
on