Installing the Avaya G350 Media Gateway
Placing the G350 on a table
If you will be installing the G350 as a tabletop unit, you need to affix the provided rubber feet to
the underside of the G350.
1. Remove the four feet from their packaging.
2. Turn the G350 upside down.
3. Position each foot into one of the mounting sites, near each corner of the chassis.
4. Press the plastic rivet into the foot with a stylus until it is firmly seated on the chassis.
Step 2: Install the media modules
When the G350 chassis is installed, you can insert the media modules. Each module is shipped
with two thumb screws for securing the position of the module in the G350 chassis.
Note:
The required media modules are usually pre-installed in the G350 chassis. If this
Note:
is the case, skip this step. Read this section only if the media modules are not
pre-installed, or if you want to replace modules or add new media modules.
Before inserting media modules into the G350 chassis
Do not install an unsupported combination of media modules. See
●
Allocate a permissible slot to each media module. See
●
!
WARNING:
The Avaya G350 Media Gateway must not be operated with any open slots.
WARNING:
Failure to cover empty slots with the supplied blank plates can cause overheating
due to inadequate air distribution.
32 Installation and Upgrades for the Avaya G350 Media Gateway
Combination
Allocating slots
on page 33.
limitations.