Chapter 3: Configuring V.150.1 In Communication Manager; Configuring V.150.1 - Avaya G450 Manual

Chapter 3: Configuring V.150.1 in

Configuring V.150.1

Before you begin
V.150.1 is only supported by MP160 Media Processor modules installed in the G450.
You must enable RFC2833 Telephony Events on SIP trunks and IGCs.
Procedure
1. Access the Communication Manager administrative SAT interface.
2. At the SAT enter change signaling-group n to open the change signaling-
3. Access page 1.
4. In the DTMF over IP field, type rtp-payload.
5. At the SAT enter change system-parameters ip-options to open the
6. Access page 2.
7. In the Intra-System IP DTMF Transmission Mode field, type rtp-payload.
8. At the SAT enter change ip-codec-set [ n ] to open the change ip-codec-set
9. Access Page 2.
Configuring V.150.1 on the Avaya G450 Branch Gateway
Communication Manager
For instructions on accessing the Avaya Aura
the Branch Gateway, see
group screen.
n is the signaling group number.
system-parameters ip-options screen.
screen.
n is the codec set number (1–7).
For example:
change ip-codec-set 1
Accessing the registered
IP Codec Set
Mode
®
Communication Manager through
MGC.
Page
Allow Direct-IP Multimedia? n
Redundancy
2 of 2
July 2012 13