Administer The Media Gateway - Avaya G700 Installation And Upgrades

Administer the Media Gateway

To perform the procedures in this section, telnet to the primary controller, log in, and open a SAT session.
!
CAUTION:
Before administering a media gateway, make sure that the gateway has been fully
configured.
Add Media Gateway
1. At the SAT prompt, type add media-gateway <number>
where <number> is the gateway number from 1 to n . (n is 50 for an S8300 and 250 for an
S8700).
The S8300 displays the Media Gateway screen.
Add Media Gateway Screen
change media-gateway 1
Number: 1
Name: Swainsons
IP Address:
Network Region: 1
Site Data:
Complete the Name field with the hostname assigned to the G700 Media Gateway.
2.
3. Complete the Identifier field with the serial number of the G700 Media Gateway. You can
obtain the serial number by typing the show system command at the MGP command line.
!
CAUTION:
Be sure the serial number for the G700 Media Gateway you enter in this procedure matches
exactly the serial number displayed in the show system command. The serial number is
case-sensitive, and if entered incorrectly, will prevent the S8300 Media Server from
communicating with the G700 Media Gateway.
Installation and Upgrades for G700 with S8300 or S8700
555-234-100 — Issue 3 — May 2003
3 Installing a New G700 with an S8300: Administer Communication Manager
MEDIA GATEWAY
MAC Address:
Slot Module Type
V1:
V2:
V3:
V4:
V8:
V9:
Page
Identifier: 012X06230551
Location: 1
Registered? n
1 of 1
153