Retrans; Rsize - IBM WebSphere XS40 Command Reference Manual

Datapower xml security gateway
Table of Contents

Advertisement

Guidelines
Refer to RFC 2224, NFS URL Schema, for complete information about using an NFS
URL.

retrans

Specifies the maximum number of RPC minor time outs to allow before the
transaction fails.
Syntax
retrans count
Parameters
count
Guidelines
Used in conjunction with the timeo command to specify behavior in response to
RPC minor time outs and subsequent retransmission attempts.
The retrans command specifies the number of RPC minor time outs that are
tolerated per NFS transaction before an NFS read or write error is declared. The
timeo command provides a base value to determine the interval between the RPC
time out and the subsequent retransmission attempt.
For example, assuming default values (3 for retrans, and 0.7 seconds for timeo),
RPC time outs are dealt with as follows.
1. In response to the first RPC time out, the appliance waits 0.7 seconds and then
2. In response to the second RPC time out, the appliance doubles the initial time
3. In response to the third RPC time out, the appliance doubles the previously
4. In response to the fourth time out, which is greater than the value specified by
The interval between RPC time outs and a subsequent retransmission will never
exceed 6 seconds.
Related Commands
timeo

rsize

Specifies the size of each read operation.
<path> must match or be more specific than the NFS export that is
provided by the target server. For example, the server provides an export
of XML/stylesheets, the <path> portion can specify XML/stylesheets or
XML/stylesheets/financialServices, (if there is a financialServices
subdirectory).
Specifies the maximum number of RPC minor time outs to tolerate before
an NFS transaction is abandoned and an NFS failure is declared. Use an
integer in the range of 1 through 60. The default is 3.
retransmits.
out value to 1.4 seconds and then retransmits.
used time out value to 2.8 seconds and then retransmits.
the retrans command, the appliance declares an NFS read or write error.
Chapter 54. NFS Static Mounts configuration mode
513

Advertisement

Table of Contents
loading

Table of Contents