Table of Contents
Advertisement
Chapter 39. LDAP Search Parameters configuration mode
This chapter provides an alphabetic listing of commands that are available in
LDAP Search Parameters configuration mode.
To enter this configuration mode, use the Global ldap-search-parameters
command.
Many of the commands that are listed in "Common commands" on page 2 and
most, but not all, of the commands that are listed in Chapter 114, "Monitoring
commands," on page 949 are also available in this configuration mode.
base-dn
Specifies the base DN to begin the search.
Syntax
base-dn DN
Parameters
DN
Guidelines
The base-dn command specifies the distinguished name (DN) relative to which the
LDAP search is to be performed. This value identifies the entry level of the tree
used by the scope command.
Related Commands
scope
filter-prefix
Specifies the prefix of the LDAP filter expression.
Syntax
filter-prefix prefix
Parameters
prefix
Guidelines
The filter-prefix command specifies the string prefix to construct an LDAP filter
expression, as defined in LDAP: String Representations of Search Filters. This string is
added before the user name to construct the LDAP filter to search for the DN of
the user.
If the prefix is (&(mail= and the user name is bob@example.com and the suffix is
)(c=US)), the LDAP search filter would be (&(mail=bob@example.com)(c=US)).
© Copyright IBM Corp. 1999, 2008
Specifies the base DN for the search.
Specifies the prefix of the filter expression.
379
Advertisement
Table of Contents
