Table of Contents
Advertisement
Parameters
URL
Guidelines
The response-report-target command identifies where to send conformance reports
for responses. This command is meaningful only when the value for the
response-report-level command is always, failure, or warning.
Examples
v Sends conformance reports for conformance failures for responses to
result-is-conformance-report
Determines whether to use conformance analysis as output.
Syntax
result-is-conformance-report {on | off}
Parameters
on
off
Guidelines
The result-is-conformance-report command indicates whether the conformance
analysis is delivered as a results action or is delivered to the next action in the
processing rule. When delivered as a results action, the intended purpose is with
a loopback XML firewall, which returns the results to the client.
Examples
v Specifies that analysis results are used as output.
Specifies the location to send conformance reports. Use the following URL
format:
protocol://host/URI
datapower.com/conform with the HTTP protocol.
# response-report-level failures
# response-report-target http://datapower.com/conform/responses
Delivers a conformance analysis as a results action.
(Default) Delivers the original message, possibly modified by one or more
style sheets, to the next document processing action.
# result-is-conformance-report on
Chapter 9. Conformance Policy configuration mode
205
Advertisement
Table of Contents
