Wsrm-Source-Request-Ack-Count; Wsrm-Source-Request-Create-Sequence; Wsrm-Source-Response-Create-Sequence - IBM WebSphere XS40 Command Reference Manual

wsrm-source-request-ack-count

Specifies the number of messages to send before requesting acknowledgement.
Syntax
wsrm-source-request-ack-count numberOfMessages
Parameters
numberOfMessages
Guidelines
The wsrm-source-request-ack-count command specifies the number of messages
that the a Reliable Messaging source sends before including the AckRequested
SOAP header to request an acknowledgement.
Related Commands
wsrm, wsrm-destination-accept-offers, wsrm-source-request-create-sequence,

wsrm-source-response-create-sequence

wsrm-source-request-create-sequence

Indicates whether to create a source from the backend to the server.
Syntax
wsrm-source-request-create-sequence {on | off}
Parameters
on
off
Guidelines
The wsrm-source-request-create-sequence command indicates whether to create a
Reliable Messaging source from the backend to the server when there is SOAP data
to sent to the server and when there is no Reliable Messaging source that was
created by a MakeOffer from the server. The Reliable Messaging source is created
by sending a CreateSequence SOAP request to the server address.
Related Commands
wsrm, wsrm-source-exponential-backoff, wsrm-source-inactivity-close-interval,
wsrm-source-make-offer, wsrm-source-maximum-queue-length,
wsrm-source-request-ack-count, wsrm-source-retransmission-interval,
wsrm-source-retransmit-count
wsrm-source-response-create-sequence
Indicates whether to create a source from the front side to the client.
Syntax
wsrm-source-response-create-sequence {on | off}
Use an integer in the range of 1 through 256. The default is 1.
Creates a Reliable Messaging source.
(Default) Does not create a Reliable Messaging source.
Chapter 49. Multi-Protocol Gateway configuration mode
485