Table of Contents
Advertisement
Chapter 56. Peer Group configuration mode
This chapter provides an alphabetic listing of commands that are available in Peer
Group configuration mode.
To enter this configuration mode, use the Global peer-group command.
All of the commands that are listed in "Common commands" on page 2 and most,
but not all, of the commands that are listed in Chapter 114, "Monitoring
commands," on page 949 are also available in Peer Group configuration mode.
type
Identifies the peer group type.
Syntax
type slm
Parameters
slm
Guidelines
The firmware supports only the SLM type.
Examples
v Enters Peer Group configuration mode to create the SLM-Group1 Peer Group.
url
Identifies a member of the current peer-group.
Syntax
url member
Parameters
member
Guidelines
When configuring a peer group you must add this DataPower appliance to the
peer group list; the peer group lists must be identical across all group members.
© Copyright IBM Corp. 1999, 2008
Specifies a token for an SLM Monitoring Peer Group.
Identifies the peer group as of type SLM.
# peer-group SLM-Group1
Peer Group configuration mode
# type slm
#
Identifies a peer group member by IP address or domain name.
519
Advertisement
Table of Contents
