Chapter 43. Message Count Monitor Configuration Mode; Distinct-Sources; Filter - IBM WebSphere XS40 Command Reference Manual

Chapter 43. Message Count Monitor configuration mode

This chapter provides an alphabetic listing of commands that are available in
Message Count Monitor configuration mode.
To enter this configuration mode, use the Global monitor-count command.
Message Count Monitor configuration mode enables the creation of a count
monitor, a counter-based object that monitors and controls a target message class.
All of the commands that are listed in "Common commands" on page 2 and most,
but not all, of the commands that are listed in Chapter 114, "Monitoring
commands," on page 949 are also available in Message Count Monitor
configuration mode.

distinct-sources

Specifies the number of distinct IP addresses to track.
Syntax
distinct-sources count
Parameters
count
Guidelines
The distinct-sources command specifies the maximum number of IP addresses to
track. When too many distinct counts are observed, the addresses not observed in
the longest amount of time are discarded.

filter

Specifies a threshold value and control procedure to implement should the
threshold value be exceeded.
Syntax
filter name interval threshold burst-limit control-procedure
no filter name
Parameters
name
interval
© Copyright IBM Corp. 1999, 2008
Specifies the maximum number of IP addresses to track. The default is
10000.
Specifies the name of the object.
The name can contain a maximum of 32 characters. For restrictions, refer to
"Object name conventions" on page xxiv.
Specifies the measurement interval in milliseconds.
413