Parameters
URL
Guidelines
If config-mode is set to import, you must specify both the location and type of the
remote configuration resource with the import-url and import-format commands.
Related Commands
config-mode, import-format
Examples
v Creates the test application domain. Identifies a remote configuration resource
local-ip-rewrite
Indicates whether to rewrite the local IP address during an import.
Syntax
local-ip-rewrite {on|off}
Parameters
on
off
Guidelines
If config-mode is set to import, use the local-ip-rewrite command to indicate
whether to rewrite the local IP address during an import.
Related Commands
config-mode
maxchkpoints
Sets the configuration checkpoint limit.
Syntax
maxchkpoints count
Specifies the location of the remote configuration file.
at the specified URL.
# domain test
New Application Domain configuration
# config-mode import
# import-url
http://www.datapower.com/configs/AppDomainTest.cfg
# import-format xml
# exit
#
(Default) Rewrites the IP address in the package to match the equivalent
interfaces on the appliance during an import. In other words, a service
bound to eth1 in the package is rewritten to bind to eth1 during the
import.
Retains the IP addresses from the package.
Chapter 5. Application Domain configuration mode
177