Table of Contents
Advertisement
Chapter 21. FTP Poller Front Side Handler configuration mode
This chapter provides an alphabetic listing of commands that are available in FTP
Poller Front Side Handler configuration mode.
To enter this configuration mode, use the Global source-ftp-poller command.
While in this configuration mode, define the client-side traffic handler.
All of the commands listed in "Common commands" on page 2 and most, but not
all, of the commands listed in Chapter 114, "Monitoring commands," on page 949
are available in these configuration modes.
delay-time
Specifies the time period between polling intervals.
Syntax
delay-time interval
Parameters
interval
Guidelines
The delay-time command specifies the number of milliseconds to wait after the
completion of one poll before starting the next interval. This interval is not the
polling interval. The interval is the delay between polling intervals.
error-delete
Indicates whether to delete a file after a processing failure.
Syntax
error-delete {on | off}
Parameters
on
off
Guidelines
The error-delete command indicates whether the input or processing renamed file
should be deleted when it could not be processed.
error-rename-pattern
Specifies the rename pattern when a file could not be processed.
© Copyright IBM Corp. 1999, 2008
Specifies the delay between polling intervals in milliseconds. Use an
integer in the range of 25 through 100000. The default is 60000.
Deletes the input or processing renamed file if it could not be processed.
(Default) Does not delete the input or processing renamed file if it could
not be processed.
287
Advertisement
Table of Contents
